In the process of installing the piston rod, in order to improve the assembly quality of its equipment, it should effectively ensure that the matching clearance between the piston and the cylinder meets the requirements before installation, and check whether the tolerances of the cylinder liner are qualified.
After the cylinder piston rod is checked and qualified, when installing a new sealing rubber ring, it should be ensured that the sealing rubber ring is flat and not twisted. And in this process, do not stick to the oil, so as not to soften the rubber, weaken the elasticity and lose the sealing effect. At the same time, an appropriate amount of sealant can be applied around the sealing ring, and the application should be continuous, uniform and without interruption.
The piston rod will effectively put the cylinder into the cylinder block. During the operation, it is mainly used to press the cylinder liner with even force with both hands, and effectively check that each cylinder is higher than the upper plane of the cylinder block, so as not to tighten the cylinder. The cylinder head is deformed or the seal is not tight when the body bolts. If there are conditions, the cylinder gasket and cylinder head should be installed, and no leakage should be considered as qualified.
www.ht-tube.com